Oil & gas guide

Shale and Fracking Explained: How It Works, Risks, Bans

How horizontal drilling and fracking opened up shale oil and gas, what it did to US output and prices, and the facts on water, earthquakes and methane.

Updated 6 min read 1,314 words

In 2008 the United States produced about 5 million barrels of crude a day and was preparing to import more liquefied natural gas. By 2024 it was producing a record 13.2 million barrels a day, the most of any country in history, and had become the world’s largest LNG exporter. The reason is shale: oil and gas trapped in dense rock that two techniques, horizontal drilling and hydraulic fracturing, made it possible to produce at scale. This guide explains how it works, what it changed, and the real environmental trade-offs.

What shale is

Shale is a fine-grained sedimentary rock formed from mud on ancient sea floors. Rich in organic matter, it is the source rock where most oil and gas originally formed. In conventional fields, oil and gas migrated out of the shale into porous sandstone or limestone and collected under a seal. Plenty stayed behind in the shale, but the rock is so tight (its permeability is measured in nanodarcies, thousands of times lower than conventional reservoirs) that it barely flows into a normal vertical well.

The industry uses “tight oil” and “shale gas” for hydrocarbons produced from these low-permeability formations, whether strictly shale or related tight sandstones and carbonates.

How a shale well works

Two techniques, each decades old, came together in Texas in the late 1990s and 2000s.

Horizontal drilling. A well is drilled down to the shale layer, often 2 to 3 km deep, then steered sideways to run along the formation. Modern laterals commonly stretch 3 km, and some exceed 5 km. A horizontal well touches far more rock than a vertical one.

Hydraulic fracturing. Crews pump fluid into the lateral at pressures high enough to crack the rock, working in 30 to 80 or more sections (“stages”) along its length. The fluid is about 90% water, 9% sand (“proppant”) and around 1% chemical additives such as friction reducers, biocides and gels. When pumping stops, the sand grains hold the hairline fractures open and oil or gas flows to the well.

George Mitchell’s company spent most of the 1990s experimenting in the Barnett Shale near Fort Worth before a cheaper “slickwater” recipe made shale gas pay in 1998. Devon Energy, which bought Mitchell in 2002, added horizontal laterals. The method spread to the Haynesville, Marcellus, Bakken, Eagle Ford and then the Permian.

What shale did to US energy

Indicator Around 2008 2024
US crude production ~5.0 million b/d ~13.2 million b/d (record)
Share of US crude from tight oil small ~two-thirds
US dry gas production ~55 billion ft³/day ~103 billion ft³/day
US LNG exports none (importer) ~88 Mt, world’s largest
Permian Basin crude output ~0.9 million b/d ~6.3 million b/d

Figures rounded from EIA data. US output rose again in 2025, though more slowly, as productivity gains offset fewer drilling rigs.

The consequences reached far beyond the US:

  • Oil prices. Shale growth helped trigger the 2014 to 2016 price collapse, when Brent fell from over $110 to under $30, and it changed how OPEC+ manages supply. See how the oil price is set.
  • Gas prices. Henry Hub gas has mostly traded between $2 and $4 per MMBtu since 2010, far below Europe and Asia, which gave US industry cheap feedstock.
  • Coal. Cheap gas pushed coal out of US power generation. Coal fell from about 48% of US electricity in 2008 to around 15 to 16% in 2024, the single largest cause of the fall in US power-sector CO₂.
  • Energy security. The US became a net exporter of petroleum in 2020 and its LNG became Europe’s main replacement for Russian gas after 2022.

Why shale behaves differently

Shale wells come online fast and fade fast. A typical well loses 60 to 70% of its initial output within a year, then declines slowly for many years after. To hold production steady, operators must drill and complete new wells continuously.

Illustrative shale well decline (hyperbolic, rounded): Month 1 output: 1,000 b/d After 12 months: ~350 b/d (≈ −65%) After 24 months: ~230 b/d First-year cumulative: ~210,000 bbl A field producing 1 million b/d with this profile needs hundreds of new wells a year just to stand still.

That has one big upside for markets: shale responds to price within six to twelve months. When prices rise, rigs return; when they fall, drilling stops and output rolls over. In the Dallas Fed Energy Survey for the first quarter of 2025, executives said they needed about $65 a barrel WTI on average to profitably drill a new well, with large Permian operators below that and smaller firms above.

Water use and wastewater

Fracking uses a lot of water in a short time. Recent Permian wells often take tens of thousands of cubic metres each (commonly 10 to 20 million US gallons), several times more than a decade ago because laterals are longer and completions more intense. That is small compared with farming in the same regions, but it is concentrated in dry areas.

The bigger problem is what comes back up. Shale wells produce large volumes of salty produced water, often several barrels per barrel of oil in the Permian, sometimes laced with naturally occurring radioactive material and hydrocarbons. Most is injected into deep disposal wells; a growing share is recycled for new fracks. Spills at the surface and poorly built wells, not fractures reaching aquifers kilometres above, are the main documented routes for groundwater contamination.

Earthquakes

Fracturing itself generates microseismic events too small to feel. Felt earthquakes are mostly linked to wastewater injection, which raises pore pressure on deep faults. Oklahoma, which used to record one or two magnitude 3+ quakes a year, recorded more than 900 in 2015, according to the USGS. Regulators then forced cuts in disposal volumes and the rate fell sharply.

Fracturing can occasionally trigger felt quakes directly. At Preston New Road in Lancashire, a magnitude 2.9 tremor in August 2019 led the UK government to impose a moratorium on fracking in England that November. It was lifted in September 2022 and reinstated in October 2022.

Methane and climate

Shale fields produce gas alongside oil, and where pipelines are lacking, operators have flared or vented it. Aerial and satellite surveys have found methane emission rates in parts of the Permian well above official inventories, at times several percent of gas output. New US EPA rules and industry programmes aim to cut flaring and leaks, though enforcement has shifted with each administration. The IEA’s Global Methane Tracker estimates that a large share of oil and gas methane could be avoided at low or no cost. See methane leakage for why it matters.

Shale outside the United States

Plenty of countries have shale resources; few have replicated the American boom. The US combined private mineral rights (landowners profit from drilling), deep capital markets, thousands of small operators, pipeline access and a large service industry. Elsewhere:

  • Argentina: the Vaca Muerta formation is the main success story outside North America, pushing the country’s oil output to record highs in 2024 and 2025.
  • Canada: Montney and Duvernay produce large volumes of gas and liquids.
  • China: shale gas in Sichuan has grown steadily, though deeper, more complex geology raises costs.
  • Europe: France banned fracking in 2011 and Germany effectively did so in 2017. Poland’s early shale hopes faded after disappointing wells.

The balance sheet

Shale turned the United States into the largest oil and gas producer on Earth, lowered gas prices, displaced coal and gave importers a new supplier. It also brought local water stress, induced earthquakes from wastewater, methane leaks and a business model that needs constant drilling. Both sides are real, and the balance depends heavily on regulation. For the bigger picture, see the oil dashboard, the natural gas dashboard, the United States country profile and the LNG value chain guide.

Calculators for this topic

Frequently asked questions

What is fracking?
Hydraulic fracturing, or fracking, pumps water mixed with sand and a small share of chemicals into a well at very high pressure to crack dense rock. The sand props the cracks open so oil and gas can flow out. Combined with horizontal drilling, it made it economic to produce from shale formations that were previously thought too tight.
How much US oil comes from shale?
Tight oil from shale and similar formations accounts for roughly two-thirds of US crude output, according to the EIA. US crude production averaged a record of about 13.2 million barrels per day in 2024, and nearly half of that came from the Permian Basin in Texas and New Mexico.
Does fracking cause earthquakes?
Fracturing itself usually causes only tiny tremors that people cannot feel. Most felt earthquakes linked to the industry come from injecting large volumes of wastewater into deep disposal wells. Oklahoma's spike in quakes after 2009 was mainly tied to wastewater disposal, and fell after regulators cut injection volumes.
Is fracking banned anywhere?
Yes. France banned it by law in 2011, Germany effectively prohibited unconventional fracking in 2017, and several US states, including New York and Vermont, ban it. The UK imposed a moratorium in England in 2019, briefly lifted it in 2022 and reinstated it weeks later.
Why do shale wells decline so fast?
Shale rock has very low permeability, so the fractured zone near the well drains quickly. Typical wells lose 60 to 70% of their initial output in the first year. Producers have to keep drilling new wells just to hold production flat, which is why shale output responds quickly to price changes.
What oil price do shale producers need?
It varies by basin and company. In the Dallas Fed Energy Survey for early 2025, executives said they needed about $65 per barrel of WTI on average to profitably drill a new well, with the best Permian acreage lower and other areas higher.

Sources & references

  1. U.S. EIA — Crude oil production and tight oil statistics
  2. U.S. EIA — Hydraulically fractured wells and US production
  3. U.S. Geological Survey — Induced earthquakes
  4. Federal Reserve Bank of Dallas — Dallas Fed Energy Survey
  5. IEA — Global Methane Tracker 2025

Figures in this guide are typical ranges drawn from the sources above; your own numbers depend on location, prices and equipment. Use the linked calculators for site-specific estimates.