Glossary · Coal

Pulverised coal combustion

The standard coal power technology: coal is ground to a fine powder and blown into a boiler, where it burns in suspension to raise high-pressure steam.

Mills grind coal until most particles are smaller than about 75 micrometres, roughly the texture of face powder. Hot air carries it to burners in the boiler walls. Water in the boiler tubes turns to steam, which drives a turbine and generator, then condenses and returns. Most of the world’s roughly 2,100 GW of coal capacity uses this design.

Efficiency depends mainly on steam pressure and temperature: subcritical units reach 33–38%, ultra-supercritical units 42–47%. Alternatives include circulating fluidised beds, which burn lower-grade coal and biomass, and IGCC gasification.

Related terms

All terms →
  • Supercritical and ultra-supercritical

    Steam power plants operating above the critical point of water (22.1 MPa, 374 °C); ultra-supercritical units run at about 600 °C and above for efficiencies of 42–47%.

  • Heat rate

    The fuel energy a thermal power plant consumes per kWh of electricity generated; the inverse of efficiency, usually in BTU/kWh or kJ/kWh.

  • Thermal (steam) coal

    Coal burned to raise steam for electricity and industrial heat, priced by energy content against benchmarks such as Newcastle and API2.

  • Flue gas desulphurisation (FGD)

    Equipment that scrubs sulphur dioxide from power plant exhaust, typically by spraying limestone slurry, removing 90–99% of SO₂.