How this home energy audit works
A full professional energy audit takes a few hours with a blower door and a thermal camera. This calculator does the desk part of that work in a minute: it estimates how much energy each part of your home uses, what it costs and where the biggest savings are.
It splits the house into end uses. Space heating comes from a heat-loss model: floor area times a heat-loss rate for your insulation level, multiplied by the heating degree days of your climate. Cooling uses cooling degree days in the same way. Hot water scales with the number of people and with how cold the incoming water is. Cooking, fridges, laundry, dishwasher, lighting, electronics and an electric car use typical consumption figures adjusted for household size and floor area. Each end use is priced with the right fuel and given a CO₂ figure.
Finally the calculator re-runs the model with one change at a time (a degree lower on the thermostat, one step better insulation, a heat pump, LED lighting and so on) and ranks the results by yearly saving.
The formula
Hot water = (1.6 kWh × people + 1 kWh) × 365 × (40 °C − mean outdoor temp) ÷ 30 Cooling = H × cooling degree days (22 °C) × 24 ÷ 1000 × 1.4 × share cooled ÷ SEER
Cost = Σ end-use energy × its price CO₂ = gas 0.202, oil 0.267, LPG 0.227 kg/kWh; electricity × grid intensity
The heating base sits 5 °C below the thermostat because people, appliances and sunshine provide free heat. That is why a house kept at 21 °C only needs heating when it is colder than about 16 °C outside.
Worked example
The defaults describe a 120 m² house in Berlin with average insulation (1.5 W/m²K, so H = 180 W/K), three people, the thermostat at 21 °C and a gas boiler at 88% seasonal efficiency. Gas costs €0.10/kWh and electricity €0.30/kWh.
- Berlin has about 2,550 heating degree days at a 16 °C base. Useful heat is 180 × 2,550 × 24 ÷ 1000 ≈ 11,000 kWh, so the boiler burns about 12,500 kWh of gas: €1,252.
- Hot water from the same boiler: 2,410 kWh, €241.
- Electric cooking 518 kWh (€155), one fridge-freezer 230 kWh (€69), laundry and dishwasher 417 kWh (€125), lighting with 60% LEDs 549 kWh (€165) and average electronics 650 kWh (€195).
Total: about 17,300 kWh and €2,202 a year (144 kWh/m²), of which 2,364 kWh is electricity. Heating alone is 57% of the bill. CO₂ comes to about 3.8 tonnes, 1,280 kg per person.
The ranked savings: one step better insulation saves about €417 a year, a heat pump with SCOP 3 about €147 at these prices, a degree lower on the thermostat €128, LEDs everywhere €101 and switchable power strips €23.
How to read the results
- Energy cost per year is the total across all fuels. Check it against a year of bills first.
- Energy per m² lets you compare homes of different sizes. Existing European homes commonly fall between 100 and 250 kWh/m² including heating; new builds are often below 70.
- The doughnut chart shows where the money goes, which often differs from where the kWh go: cheap gas heating can be most of the energy but a smaller share of the cost.
- The savings table is ranked by money saved each year, not by payback. Expensive measures like insulation need their installation cost weighed separately; the insulation savings calculator does that in detail.
Typical values
| End use | Typical share of household energy (cold/temperate climate) |
|---|---|
| Space heating | 50–70% |
| Hot water | 10–20% |
| Cooking | 2–6% |
| Fridges and freezers | 2–5% |
| Lighting | 2–6% (lower with LEDs) |
| Electronics and standby | 4–10% |
In hot humid climates such as Malaysia, heating disappears and air conditioning becomes the largest single item, with hot water much smaller because the cold water is already warm.
Tips for acting on the audit
- Start with the free fixes. Lower thermostat, shorter showers, standby off and a lower boiler flow temperature cost nothing.
- Then the cheap ones. LEDs, draught-proofing, radiator reflectors and a smart thermostat pay back in one to three years.
- Plan the big ones together. Insulate before you size a heat pump; a smaller heat load means a smaller, cheaper unit. The heat pump calculator shows running costs, and heating cost comparison compares fuels at your prices.
- Track it. Compare winter bills using degree days so a mild winter does not look like a saving.
Limitations
This is a model, not a measurement. Heat loss per m² is a single number per insulation level and ignores house shape, window area, orientation and air tightness. Climates come from monthly averages, and appliance figures are typical rather than your exact models. Cooling uses a simple factor for sun, internal heat and humidity. Use the result to find the big items and rank options, then confirm the expensive decisions with quotes and, ideally, a professional survey.
Method & assumptions
Space heat = heat-loss coefficient (W/K per m² by insulation level × area) × heating degree days × 24 ÷ 1000, divided by the system efficiency (or SCOP). Hot water = (1.6 kWh × people + 1 kWh) per day of useful heat, scaled by (40 °C − annual mean temperature) ÷ 30 because cold water is warmer in hot climates. Cooling = heat-loss coefficient × cooling degree days (22 °C) × 24 ÷ 1000 × 1.4 × share cooled ÷ SEER. Appliance, lighting and electronics use typical values scaled by household size and floor area. Savings re-run the model with one change at a time.
Frequently asked questions
What uses the most energy in a home?
How much energy does an average house use per year?
Can I do a home energy audit myself?
What is a good kWh per square metre figure?
Which energy saving measure pays back fastest?
Why does my result differ from my bill?
Sources & references
Embed this calculator
Free for blogs, installers, schools and NGOs. Copy the code below; it updates itself automatically.