How this calculator works
Air-conditioning is the single biggest item on most Malaysian electricity bills. This tool answers the two questions people ask before buying one: which size do I need, and what will it cost me every month?
It first estimates the room’s cooling load in BTU per hour from the floor area, ceiling height, sun exposure, roof exposure, the number of people and any heat sources such as cooking. It then picks the smallest standard unit sold in Malaysia that covers the load: 1.0, 1.5, 2.0, 2.5 or 3.0 HP. Finally it converts that unit’s cooling output into electricity using its efficiency and a typical average load, and prices the extra kWh with the real TNB, SESB or Sarawak Energy domestic tariff.
The formula
The 600 BTU/h per m² figure is a hot-humid-climate rule that matches the sizes Malaysian retailers recommend (1.0 HP for a typical 3 × 4 m bedroom). 1 kW of cooling is 3,412 BTU/h.
The cost is a difference between two complete bills, not kWh × a flat rate. That matters with the July 2025 TNB tariff, because extra kWh can push you into a lower Energy Efficiency Incentive band or over the protection threshold, where AFA, the retail charge and SST kick in.
Worked example
The default is a 12 m² bedroom (3 × 4 m) with a normal amount of sun, two people and a 2.7 m ceiling:
- Load: 12 × 600 = 7,200 BTU/h, so a 1.0 HP (9,000 BTU/h) unit is enough.
- 9,000 BTU/h is 2.64 kW of cooling. At an average 65% load and an efficiency of 4.5, the unit draws about 380 W.
- Eight hours a night for 30 nights: 0.38 × 8 × 30 ≈ 91 kWh a month.
- The rest of the household uses 350 kWh. The TNB bill for 350 kWh versus 441 kWh differs by about RM51 a month, or roughly RM1.70 a night. That works out at 56 sen per extra kWh, well above the 27 sen energy charge, because the household drops from the 21 sen to the 14.5 sen EEI band.
How to read the results
- Recommended size is the nominal capacity to look for on the box or the energy label.
- Extra on your bill is what the aircond adds to your monthly bill at your current usage. The same unit costs more in a household that already uses a lot of power.
- Average power draw is the realistic figure, far below the rated input power printed on the unit, because an inverter compressor runs at part load most of the night.
- The inverter vs non-inverter table repeats the calculation with an efficiency of 4.5 and 3.0.
Typical sizes
| Size | Cooling (BTU/h) | Cooling (kW) | Typical room |
|---|---|---|---|
| 1.0 HP | 9,000 | 2.6 | Bedroom up to about 15 m² |
| 1.5 HP | 12,000 | 3.5 | Master bedroom, 15–21 m² |
| 2.0 HP | 18,000 | 5.3 | Small living room, 21–31 m² |
| 2.5 HP | 24,000 | 7.0 | Living and dining, 31–42 m² |
| 3.0 HP | 28,000 | 8.2 | Open-plan areas up to about 49 m² |
Tips to cut aircond costs
- Set 24–25 °C and use the ceiling fan; avoid “turbo” at 16–18 °C.
- Clean filters every few weeks and service the unit at least once a year; clogged coils lower efficiency noticeably.
- Close curtains on west-facing windows in the afternoon and insulate the roof space if you live on the top floor.
- Choose a unit with a high star rating on the Energy Commission label and an inverter compressor.
- Run the timer so the unit switches off in the early morning when outdoor temperatures drop.
- If you have rooftop solar, pre-cooling the house in the late afternoon uses your own solar power; see the Solar ATAP calculator.
Limitations
The sizing rule assumes a normally built Malaysian room. Rooms with large glass walls, poor insulation, many appliances or open doors need more capacity; a professional heat-load survey is better for big or unusual spaces. Average load and efficiency vary with model, outdoor temperature and thermostat setting, so treat the running cost as an estimate within about ±25%. Use the TNB bill calculator to see your whole bill, or the general air conditioner cost calculator for other countries.
Method & assumptions
Sizing: load (BTU/h) = floor area × 600 × (ceiling height ÷ 2.7) × sun factor (0.9 shaded, 1.0 normal, 1.15 sunny), × 1.15 under a roof, + 600 BTU/h per person above two, + 4,000 BTU/h for a kitchen. We pick the smallest standard unit (9,000 / 12,000 / 18,000 / 24,000 / 28,000 BTU/h, sold as 1.0 / 1.5 / 2.0 / 2.5 / 3.0 HP) that covers 95% of the load.
Energy: average electrical power = rated cooling (kW) × average load ÷ efficiency (CSPF or EER). kWh = power × hours × days. Cost: the bill for your household usage plus the aircond minus the bill without it, with the current TNB, SESB or Sarawak Energy domestic tariff.
Frequently asked questions
What size aircond do I need for my room in Malaysia?
How many BTU is 1 HP aircond?
How much does it cost to run a 1 HP aircond for 8 hours?
Is an inverter aircond worth it?
What temperature should I set my aircond to save electricity?
Is a bigger aircond better?
Sources & references
Embed this calculator
Free for blogs, installers, schools and NGOs. Copy the code below; it updates itself automatically.